Analysis of Passive RF-DC Power Rectification and Harvesting Wireless RF Energy for Micro-watt Sensors

Antwi Nimo; Tobias Beckedahl; Thomas Ostertag; Leonhard Reindl; Antwi Nimo; Tobias Beckedahl; Thomas Ostertag; Leonhard Reindl

doi:10.3934/energy.2015.2.184

AIMS Energy

2015, Volume 3, Issue 2: 184-200. doi: 10.3934/energy.2015.2.184

Previous Article Next Article

Research article Special Issues

Analysis of Passive RF-DC Power Rectification and Harvesting Wireless RF Energy for Micro-watt Sensors

University of Freiburg, Department of Microsystems Engineering - IMTEK. Laboratory for Electrical Instrumentation. Georges-Köhler-Allee 106, 79110 Freiburg, Germany

Received: 29 December 2014 Accepted: 14 April 2015 Published: 24 April 2015

In this paper, analytical modeling of passive rectifying circuits and the harvesting of electromagnetic (EM) power from intentionally generated as well as from ubiquitous sources are presented. The presented model is based on the linearization of rectifying circuits. The model provides an accurate method of determining the output characteristics of rectifying circuits. The model was verified with Advance Design System (ADS) Harmonic balance (HB) simulations and measurements. The results from the presented model were in agreement with simulations and measurements. Consequently design considerations and trade-off of radio frequency (RF) harvesters are discussed. To verify the exploitation of ambient RF power sources for operation of sensors, a dual-band antenna with a size of ~λ/4 at 900MHz and a passive dual-band rectifier that is able to power a commercial Thermo-Hygrometer requiring ~1.3V and 0.5MΩ from a global system for mobile communications (GSM) base station is demonstrated. The RF power delivered by the receiving dual-band antenna at a distance of about 110 m from the GSM base station ranges from -27 dBm to -50 dBm from the various GSM frequency bands. Additionally, wireless range measurements of the RF harvesters in the industrial, scientific and medical (ISM) band 868MHz is presented at indoor conditions.
- Ambient RF energy harvesting,
- Schottky diode rectifier,
- dual-band RF harvester,
- rectenna,
- RF to DC rectification model,
- wireless power transmission
Citation: Antwi Nimo, Tobias Beckedahl, Thomas Ostertag, Leonhard Reindl. Analysis of Passive RF-DC Power Rectification and Harvesting Wireless RF Energy for Micro-watt Sensors[J]. AIMS Energy, 2015, 3(2): 184-200. doi: 10.3934/energy.2015.2.184

Related Papers:

Abstract

In this paper, analytical modeling of passive rectifying circuits and the harvesting of electromagnetic (EM) power from intentionally generated as well as from ubiquitous sources are presented. The presented model is based on the linearization of rectifying circuits. The model provides an accurate method of determining the output characteristics of rectifying circuits. The model was verified with Advance Design System (ADS) Harmonic balance (HB) simulations and measurements. The results from the presented model were in agreement with simulations and measurements. Consequently design considerations and trade-off of radio frequency (RF) harvesters are discussed. To verify the exploitation of ambient RF power sources for operation of sensors, a dual-band antenna with a size of ~λ/4 at 900MHz and a passive dual-band rectifier that is able to power a commercial Thermo-Hygrometer requiring ~1.3V and 0.5MΩ from a global system for mobile communications (GSM) base station is demonstrated. The RF power delivered by the receiving dual-band antenna at a distance of about 110 m from the GSM base station ranges from -27 dBm to -50 dBm from the various GSM frequency bands. Additionally, wireless range measurements of the RF harvesters in the industrial, scientific and medical (ISM) band 868MHz is presented at indoor conditions.

References

[1]	Harrison RG, Le Polozec X (1994) Nonsquarelaw behavior of diode detectors analyzed by the Ritz-Galerkin method.Microw Theory Tech IEEE Trans 42: 840-846. doi: 10.1109/22.293533
[2]	McSpadden JO, Fan I, Chang K (1998) Design and experiments of a high-conversion-efficiency 5.8-GHz rectenna.Microw Theory Tech IEEE Trans 46: 2053-2060. doi: 10.1109/22.739282
[3]	Curty J-P, Joehl N, Krummenacher F, et al.(2005) A model for μ-power rectifier analysis and design.Circuits SystRegul Pap IEEE Trans52: 2771-2779.
[4]	Barnett RE, Liu J, Lazar S (2009) A RF to DC voltage conversion model for multi-stage rectifiers in UHF RFID transponders.Solid-State Circuits IEEE 44: 354-370. doi: 10.1109/JSSC.2008.2010991
[5]	Nimo A, GrgićD, ReindlLM (2012) Optimization of passive low power wireless electromagnetic energy harvesters.Sensors 12: 13636-13663. doi: 10.3390/s121013636
[6]	Nimo A, GrgićD, ReindlLM (2012) Ambient electromagnetic wireless energy harvesting using multiband planar antenna.Systems Signals Devices (SSD), 9th International Multi-Conference on 1-6.
[7]	Sample A,Smith JR (2009) Experimental results with two wireless power transfer systems.Proceedings of the 4th international conference on Radio and wireless symposium, San Diego, CA, USA, 16-18.
[8]	MikekaC,Arai H (2011) Design issues in radio frequency energy harvesting system.SustEnerg Harvesting Technologies—Past Present and Future, InTech.
[9]	Vyas RJ, Cook BB, KawaharaY, et al. (2013) E-WEHP: A batteryless embedded sensor-platform wirelessly powered from ambient digital-TV signals.Microw Theory Tech IEEE Trans 61: 2491-2505. doi: 10.1109/TMTT.2013.2258168
[10]	PinuelaM, MitchesonPD, LucyszynS (2013) Ambient RF energy harvesting in urban and semi-urban environments.Microw Theory Tech IEEE Trans 61: 2715-2726. doi: 10.1109/TMTT.2013.2262687
[11]	Joe J, Chia M, MarathA, et al. (1997) Zero bias schottky diode model for low power, moderate current rectenna.DETS'97 Proc.
[12]	Watson HA (1969) Schottky-barrier Devices.Microwave semiconductor devices and their circuit applications, New York; Maidenhead: McGraw-Hill.
[13]	Maas SA (2003) Harmonic-Balance Analysis and Related Methods.Nonlinear microw RF circuits, Boston, MA: Artech House.
[14]	SahC-T (1991) P/N and Other Junction Diodes.Fundamentals of solid-state electronics, Singapore; River Edge, NJ: World Scientific.
[15]	AudetJ (2006) Q Calculations of L-C Circuits and Transmission Lines: A Unified Approach. QEX Mag 43-51.
[16]	HUBER+SUHNER (2010)Rfid reader antenna: Spa 860/65/9/0/v (1308.17.0005).
[17]	Chen H, Chen W, Cheng Y, et al.(2003) Dualband meander monopole antenna.Antennas Propagation Society IntSymp IEEE 3: 48-51.
[18]	FriisHT (1946) A Note on a Simple Transmission Formula.Proc IRE 34: 254-256. doi: 10.1109/JRPROC.1946.234568

Reader Comments

Your name:*

Email:*
© 2015 the Author(s), licensee AIMS Press. This is an open access article distributed under the terms of the Creative Commons Attribution License (http://creativecommons.org/licenses/by/4.0)